Programming/Setup Guide
Looking to program or setup your S1 lock onto your door? This guide will break down the steps.
If you are looking to install your lock, visit here.
If you are looking for instructions on how to replace the batteries, visit here.
Basic Parameters
Door Opening Method: fingerprint, card, password, APP, mechanical key
Storage Capacity: 100PCS of door cards + fingerprints + passwords
Working Voltage: 3 No.7 AAA alkaline dry batteries
Battery Life: Up to 1 year (unlock 10 times a day)
Working Temperature: -20°C ~ 70°C
Working Humidity: 40%RH ~ 80%RH
Fitting category A: single latch
Door Thickness: 30mm-80mm
Door Prep: 54mm diameter face hole &25mm diameter latch hole
Daily Maintenance
· Installation environment: requires at least a canopy, do not keep the lock completely exposed in open air.
· Please do not scratch the fingerprint identification area with a sharp object.
· Please exchange both three batteries at the same time, do not use mixed new batteries with old ones.
· The mechanical key is a measure for emergency door opening, please keep at least 1 mechanical key in a safe place other than home(e.g. office, parents’ house).
· Please adjust the door or door frame in time if it deforms, otherwise the latch will not enter the door frame hole position smoothly.
Instructions
Note: Please install 3 x No.7 AAA alkaline dry batteries before use.
Download APP:
Log in AppStore/GooglePlay to search “YEEUU” and download the APP.
Add device:
Register and log in “YEEUU” account; click “Add Device” or click symbol “+” at the upper right corner on “Home page”; select “Auto Scan” to start searching; after the device is searched, click “next” to connect the lock to be added.
Add/use fingerprint to open the door(Applicable fingerprint version):
Log in “YEEUU” APP; select the device and enter “Settings” page; click “Fingerprint Management” to enter the page; click “Add Fingerprint” at the upper right corner and put the finger on the fingerprint identification area for admission.
Add/use door card to open the door:
Log in “YEEUU” APP; select the device and enter “Settings” page; click “Door Card Management” to enter the page; click “Add Door Card” at the upper right corner and then put the door card on the card identification area for admission.
Add Password:
Log in “YEEUU” APP; Select the device and enter the “Settings” page; click “Password Management” to enter the page; click “Add Password” to set the password; Please note that the initial device password is “123456”.
Use APP to open the door:
Log in “YEEUU” APP; select the page for the device to be entered, click the icon at the page center after your APP is connected with the lock; turn the handle to open the door when the green light flashes.
View records:
Log in “YEEUU” APP; select the page for the device to be entered; after your APP is connected with the lock, click “Opening Record/Alarm” to enter the page to view opening/alarm records.
Unbind the door lock：
Unbind the door lock: [Remove Device] button shows up when a non-administrator user performs the above mentioned operations, click it and follow the prompt to unbind.
Low Voltage Alarm:
Yellow light flashes 2 times.
Operation Failed:
Red light flashes 2 times, buzzing 2 times.
Error Lock:
Red light flashes 5 times.
Frequently Asked Question
Opening door by mobile phone fails.
Check whether the batteries are loaded and working properly; Check the networking status of mobile phone and perform operation again; Remove the batteries and re-load.
Opening door by card fails.
Check whether the batteries are loaded and working properly; Confirm whether the card has been added; Remove the batteries and re-load.
Opening door by fingerprint fails.
Check whether the batteries are loaded and working properly; Confirm whether the fingerprint has been added; Remove the batteries and re-load; Ensure that the finger is dry.
Yellow light flashes when opening the door.
Low power, please replace 3 No.7 AAA alkaline dry batteries in time.
Red light flashes 5 times when opening the door.
Error in lock, please try to unlock the door by fingerprint/- door card/password 1 minute later, or use the APP to unlock it. No response when opening the door. Please check if the batteries are loose; If the batteries are dead, please replace the batteries.
Login/registration cannot be performed normally.
Please check whether the network is running properly.
If you are looking to install your lock, visit here.
If you are looking for instructions on how to replace the batteries, visit here.